Homepage
Favoritey

 
 
Location:Home> Center
 
  Key points of installation and example introduction

 1、Maximum speed of revolution: the allowable maximum speed of revolution of clutches and brakes (see the above table) is decided by maximum speed of friction surface. If the operation at the speed higher than this speed of revolution, which will lead to failure of attaining rated torque and abnormal abrasion or deformation caused by overheating.

 2、Temperature: clutches and brakes are Grade B insulation with 40℃ of normal temperature rise. The working temperature in limited thermal equilibrium should not exceed 100℃, otherwise the loop and friction parts will be easily damaged.

 3、Humidity and water drop: if water drop is adhesive to the friction surface of clutches and brakes, the phenomenon of low friction force will occur before it is totally dried, in addition, moisture is the main reason of causing corrosion of the products, so much attention should be paid.

 4、 Foreign matter: no miscellany should be mixed into friction surface. The mixture of grease will cause low friction force, and the mixture of dust and metal particle will cause the damage of friction plate or gyration parts. The mixture of chemical agent is the main reason of generating rust and corrosion. In view of the above precautions, please use protective cover when necessary.

 5、Ventilation: because clutches and brakes will produce friction and radiate outside, the products should be installed at ventilated places. When the products are used at the places with bad ventilation and heat output, attention should be paid combining with Item 2, forced air supply cooling should be adopted when necessary.

 6、Graphic example: in order to provide convenience for users to design, some of installation examples are specially selected for users' reference. See back cover for the graphic examples.
 Installing the Sample Chart